The use of heterogeneous chemistry for the characterization of functional groups at the gas/particle interface of soot and TiO(2) nanoparticles

Détails

Ressource 1Télécharger: BIB_B8A74238BB56.P001.pdf (754.39 [Ko])
Etat: Public
Version: Author's accepted manuscript
ID Serval
serval:BIB_B8A74238BB56
Type
Article: article d'un périodique ou d'un magazine.
Collection
Publications
Institution
Titre
The use of heterogeneous chemistry for the characterization of functional groups at the gas/particle interface of soot and TiO(2) nanoparticles
Périodique
Physical Chemistry Chemical Physics
Auteur⸱e⸱s
Setyan Ari, Sauvain Jean-Jacques, Rossi Michel J.
ISSN
1463-9076
Statut éditorial
Publié
Date de publication
2009
Peer-reviewed
Oui
Volume
11
Numéro
29
Pages
6205-6217
Langue
anglais
Notes
SAPHIRID:79978
Résumé
Six gases (N((CH3)3), NH2OH, CF3COOH, HCl, NO2, O3) were selected to probe the surface of seven combustion aerosol (amorphous carbon, flame soot) and three types of TiO2 nanoparticles using heterogeneous, that is gas-surface reactions. The gas uptake to saturation of the probes was measured under molecular flow conditions in a Knudsen flow reactor and expressed as a density of surface functional groups on a particular aerosol, namely acidic (carboxylic) and basic (conjugated oxides such as pyrones, N-heterocycles) sites, carbonyl (R1-C(O)-R2) and oxidizable (olefinic, -OH) groups. The limit of detection was generally well below 1% of a formal monolayer of adsorbed probe gas. With few exceptions most investigated aerosol samples interacted with all probe gases which points to the coexistence of different functional groups on the same aerosol surface such as acidic and basic groups. Generally, the carbonaceous particles displayed significant differences in surface group density: Printex 60 amorphous carbon had the lowest density of surface functional groups throughout, whereas Diesel soot recovered from a Diesel particulate filter had the largest. The presence of basic oxides on carbonaceous aerosol particles was inferred from the ratio of uptakes of CF3COOH and HCl owing to the larger stability of the acetate compared to the chloride counterion in the resulting pyrylium salt. Both soots generated from a rich and a lean hexane diffusion flame had a large density of oxidizable groups similar to amorphous carbon FS 101. TiO2 15 had the lowest density of functional groups among the three studied TiO2 nanoparticles for all probe gases despite the smallest size of its primary particles. The used technique enabled the measurement of the uptake probability of the probe gases on the various supported aerosol samples. The initial uptake probability, g0, of the probe gas onto the supported nanoparticles differed significantly among the various investigated aerosol samples but was roughly correlated with the density of surface groups, as expected. [Authors]
Mots-clé
Aerosols , Gases , Nanoparticles , Soot , Surface Properties , Titanium , Titrimetry
Pubmed
Web of science
Open Access
Oui
Création de la notice
19/01/2010 18:30
Dernière modification de la notice
20/08/2019 16:26
Données d'usage